Marine Driveshafts
Application Data Form

Driveline Service of Portland requires the following information to properly select your driveshaft. Please complete as much of the form below as is known or applicable at present. Our staff will contact you to determine any other necessary information.


Full Name:
Phone:
E-mail:
List me as: an individual
a business
Company:
Address:
City:
State:
Zip:
Fax:

Name of vessel:  
Type of vessel:  
Hull design: Planing Displacement Towing
Type of propulsion: Conventional Jet    

Engine model:  
Horsepower: At what RPM:
Marine gear model: Reduction ratio:
Torsional coupling to be utilized:   Yes No  

Drive flange:     Driven flange:  
Diameter:   Diameter:
Bolt circle:   Bolt circle:
Number of holes:   Number of holes:
Pilot diameter:   Pilot diameter:

Speed range of driveshaft:   RPM to RPM
Distance between drive and drive flanges:  
Desired location of support bearings:  
Horizontal offset of flanges:   Distance: Degrees:
Vertical offset of flanges:   Distance: Degrees:
Does the shafting pass through a bulkhead:   Yes No  
If so, is a water tight seal required:   Yes No  
Use of vessel:   Commercial Pleasure
Anticipated operation, annually:   hours  
 
Additional Comments:
   

Call Us Toll-Free: 800-227-8608
Email Us:info@driveshafts.com
© Copyright 2008 Driveline Service of Portland, Inc. All rights reserved.